So yes, for EL7, skip the ‘sed’ commands. I am not sure what to make of this but will supply a further update when I have time to dig a little deeper. This is where the instructions for EL6 and EL7 part ways. I am on a Lenovo G laptop, I am running Fedora 25, and lspci returns, among other things,. By clicking “Post Your Answer”, you acknowledge that you have read our updated terms of service , privacy policy and cookie policy , and that your continued use of the website is subject to these policies.

Uploader: Juran
Date Added: 9 February 2005
File Size: 23.83 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 64832
Price: Free* [*Free Regsitration Required]

After successful setup of the driver, users new to wireless often report problems like “Error for wireless request “Set Encode” 8B2A: RPM reported as “Not a valid File”! This is where the instructions for EL6 and EL7 part ways. So, we also need to apply the following patch wl-kmod-fix-ioctl-handling. Sign up or log in Sign up using Google.

RPM resource broadcom-wl

Thank you more than a ton. Problem solved by recomendations on http: I would accept this as an answer if I was able to do so.

If you’re running EL 7. Now, with the current driver version 6.

RPM resource broadcom-wl

P — 2. To remedy this, we’ll run the following sed replacement commands: The problem lies in Linux-firmware.


Regulatory domain changed to country: The initial instructions are fine for Intel 64 bit machines but should note that Intel 32 bit machines require the kernel- PAE -devel package.

But when you attempt to connect, it will just keep asking for your password even though there is nothing wrong there. So, for EL6, you should follow through step 3a, while for EL7, you need to apply only the patch from fedoraa 3a, and sed commands from step 3b, applicable to EL7 only, and compile it as shown in this step 3a. The above fix is not persistent after reboot and requires me to execute modprobe brcmfmac before the wireless interface bcm4131 visible.

After a fresh install of Broavcom 27, the wifi card is not detected after the running the first system update. Compiling the Broadcom driver module specifics required for EL7 Step 4a: Again, this should be resolved by repeated reboots until the firmware is loaded properly.

After some lengthy troubleshooting online I am still no closer to the solution.

Powered by Askbot version 0. Bck4311 device not found on Fedora Loading the driver module into kernel Having successfully compiled the driver module, you can now load it into kernel, and eventually set up automatic driver load on system boot to do all this, you’ll have to assume root privileges.

Recent Drivers  LENOVO 3000 V100 MODEM DRIVER

And yes, your driver module works Step 3b: Vostro Dec 19 So yes, for EL7, skip the ‘sed’ commands.

b43 and b43legacy

No wifi in the system menu or Networks application. Due to the fact I didn’t already have the kernel-devel package installed and it is not a required dependency I had to include the following two steps BEFORE running the modprobe command: I just installed Fedora 25 on my laptop and the wifi icon is missing from the system menu and there is no wifi option in the Networks application.

Thanks brpadcom the answer. I researched a bit and found out that it is because my wireless adapter is a Broadcom adapter. Broadcom Limited BCM The ‘ndiswrapper’ kernel module can be removed, provided you don’t use it for anything else but wireless driver – but this is not necessary. I am on a Lenovo G laptop, I am running Fedora 25, and lspci returns, among other things,